Powerful multicolor RGB + variable white CCT LED strip 130 LEDs/m 5-in-1 2800 Lumens/m

Powerful multicolor RGB + variable white CCT LED strip, ideal for creating colorful lighting or the desired white tone in a bar, nightclub, lobby, or public venue.
The combination of RGB and variable white allows for an infinite number of shades and colors, while providing increased brightness for room lighting.
DMX control enables you to set the desired shades with extreme precision (over 1,000 billion shades).

Its power of 35W per meter delivers up to 2800 lumens per meter when all LEDs are on (in white).
Note that standard controllers do not allow all LEDs to be lit simultaneously at full power. However, this is possible if the strip is controlled via 5-channel DMX, with all channels set to maximum value (255).

The strip requires an RGB+CCT controller to adjust the color, white tone, and brightness.

The strip is available in IP20 for indoor use, and in waterproof versions for outdoor or wet areas (kitchens, bathrooms).

The 12 mm wide strip operates at 24V DC and can be cut every 50 mm.

Build your ready-to-use kit

Strip only	To operate the strip, you need a 24V 220W minimum power supply. If you do not already have one, you must add a power supply to the essential accessories. Otherwise, you can purchase the strip alone.
Power supply + strip kit +	Minimum kit to operate your LED strip. It connects to 230V mains and the LED strip connects to the 12/24V output of the power supply. Add the power supply to the accessories list.
Power supply + controller + strip kit + +	To assemble this kit, add the following accessories: - 1 power supply - 1 RGB+CCT controller with remote You will get a complete kit with a remote control to turn on, off, and adjust the brightness using the radio-frequency remote.
Power supply + Wifi dimmer + strip kit + +	To assemble this kit, add the following accessories: - 1 power supply - 1 Wifi controller With this complete kit, you can turn on, off, and adjust the brightness via Wifi using your phone or tablet.
Power supply + DMX dimmer + strip kit + +	To assemble this kit, add the following accessories: - 1 power supply - 1 RGB DMX controller Complete kit operating in DMX (excluding console). The DMX controller allows you to turn on, off, and adjust brightness, colors, and white tones according to the signal sent by your DMX console. 5 channels are required to control the LED strip. LTech brand controller designed for professionals for intensive and durable use.

Multicolor RGB + variable white strips (RGBCCT)

This strip requires an RGB + variable white controller for operation. It allows you to turn on, off, adjust brightness, colors, and white tone.

The 6 wires, black (+), red (R), green (G), blue (B), yellow (warm white/WW), and white (cool white/CW) should be connected as follows:

Wiring diagram for multiple strips with a total length exceeding 5 meters. The cable used has 6 wires (+, red (R), green (G), blue (B), cool white (CW), and warm white (WW)).

Precautions when handling and installing an LED strip

LED strips can be bent lengthwise with a minimum radius of 5 cm.
They should never be bent sideways.

If you need to make 90° angles, you must cut the strip into sections and connect them either with a suitable angle connector, or preferably, by soldering flexible cable (flat ribbon) between the two sections.

Do not bend or distort the LED strips:

Choosing an LED strip

How to choose the LED strip best suited to your needs?

To quickly and easily find the LED strip that will best fit your lighting project, see our guide